Door & Nose Puller
for Safe Deposit Boxes No. DP-7B |
If the lock core has been pulled and use of the guard key has not opened the door, then it is time to apply the DP-7B Door Puller Set. Place the stepped Spacer Block onto the hook unit. The 3 different diametered steps of .345" (2.15cm), .562" (1.43cm) and .680" (1.73cm) make it adaptable to 3 different sizes of plug holes. Place the correct diameter step into the hole. Have the hook end set against the inside back wall of the door, then tighten the knurled nut to hold the hook in place. The flat surface on the outside of the hook unit should be in a level position.The long flat blade is then fitted onto the holding slot, along with the remainder of the Puller unit, as shown above. Position feet away from the centers of adjacent doors,to minimize the possibility of distortion. The knurled knob is then turned until the door is pulled out.
|
Nose Puller for Safe Deposit Boxes
NP-4B This heavy wrought iron and bar steel set is expertly machined and finished to effectively pull out a lock core from a safe deposit door. Simply turn screw into the center of core's keyway to act as an anchor. Then slip the spacer block into place and tighten by turning knurled knob. Continue turning clockwise, slowly and gradually until the entire core is drawn out. Then use the guard key and disengage bolt. If door does not open, then it becomes necessary to use the Door Puller device (No. DP-7B). The Nose Puller can also be used for removing the plug from a padlock. It is packed in a steel case. |
Replacement Parts for the Door & Nose Puller Set:
No. DP-7B-1 Hooked Anchoring Post No. DP-7B-2 Knurled Nut only, to fit Anchor Post & Leg No. DP-7B-3 3 Diameter Spacer Block No. DP-7B-4 Flat Blade No. DP-7B-5 Slotted Leg with Foot No. DP-7B-6 Handle No. NP-4B-4,5 Ball Thrust Bearing & Knurled Knob for Thrust Bearing |
Replacement Parts for the Nose Puller Set:
No. NP-4B-1 Screw Retainer No. NP-4B-2 Standard Hex Head Sheet Metal Screw - 10 per Pack No. NP-4B-3 Threaded Shaft No. NP-4B-4,5 Ball Thrust Bearing & Knurled Knob No. NP-4B-6 Handle No. NP-4B-7 Spacer Block |
© COPYRIGHT 2023. ALL RIGHTS RESERVED.
|
Hudson Lock, LLC |